Sunday, December 18, 2011

Frist test print



The TOM was completely built up, testing was the following task to accomplish. I was panicking on how to feed the ASB coil to the stepstruder and by trial and error I managed to get it in.

28 minutes later the first Makerbot test print, a cube, both side of 2 cm and 1 cm height. I was very satisfy on the result, but I also found out the a few layers at the bottom are smaller.

When watching at the video you'll realized that the filling in the model is rather tight, I follow the  setting from "How to print" the infill is 40.

No comments:

Post a Comment